Dear Dan, cc Mark, this sounds exactly like the scenario I'm looking at. We have rolling snapshots on RBD images on currently ca. 200 VMs and increasing. Snapshots are daily with different retention periods. We have two pools with separate hardware backing RBD and cephfs. The mem stats I sent are from an OSD backing cephfs, which does not have any snaps currently. So the snaps on other OSDs influence the memory usage of OSDs that have nothing to do with the RBDs. I also noticed a significant drop of memory usage across the cluster after restarting the OSDs on just one host. Not sure if this is expected either. Looks like the OSDs do collect dead baggage quite fast and the memory_target reduces the caches in an attempt to accommodate for that. The fact that the kernel swaps this out in favour of disk buffers on a system with low swappiness where the only disk access is local syslog indicates that this is allocated but never used - a quite massive leak. It currently looks like that after only a couple of days the leakage exceeds the mem target already. I don't want to have the occasional OOM killer on my operations team. For now I will probably adopt a reverse strategy, give up on memory_target doing something useful, increase the minimum cache limits to ensure at least some caching, have swap take care of the leak and restart OSDs regularly (every 2-3 months). Would be good if this could be looked at. Please let me know if there is some data I can provide. Best regards, ================= Frank Schilder AIT Risø Campus Bygning 109, rum S14 ________________________________________ From: Mark Nelson <mnelson@redhat.com> Sent: 15 July 2020 18:36:06 To: Dan van der Ster Cc: ceph-users Subject: [ceph-users] Re: OSD memory leak? On 7/15/20 9:58 AM, Dan van der Ster wrote:
Hi Mark,
On Mon, Jul 13, 2020 at 3:42 PM Mark Nelson <mnelson@redhat.com> wrote:
Hi Frank,
So the osd_memory_target code will basically shrink the size of the bluestore and rocksdb caches to attempt to keep the overall mapped (not rss!) memory of the process below the target. It's sort of "best effort" in that it can't guarantee the process will fit within a given target, it will just (assuming we are over target) shrink the caches up to some minimum value and that's it. 2GB per OSD is a pretty ambitious target. It's the lowest osd_memory_target we recommend setting. I'm a little surprised the OSD is consuming this much memory with a 2GB target though.
Looking at your mempool dump I see very little memory allocated to the caches. In fact the majority is taken up by osdmap (looks like you have a decent number of OSDs) and pglog. That indicates that the memory Do you know if this high osdmap usage is known already? Our big block storage cluster generates a new osdmap every few seconds (due to rbd snap trimming) and we see the osdmap mempool usage growing over a few months until osds start getting OOM killed.
Today we proactively restarted them because the osdmap_mempool was using close to 700MB. So it seems that whatever is supposed to be trimming is not working. (This is observed with nautilus 14.2.8 but iirc it has been the same even when we were running luminous and mimic too)
Cheers, Dan
Hrm, it hasn't been on my radar, though looking back through the mailing list there appears to be various reports over the years of high usage (some of which theoretically have been fixed). Maybe submit a tracker issue? 700MB seems quite high for osdmap, but I don't really know the retention rules so someone else who knows that code better will have to chime in.
autotuning is probably working but simply can't do anything more to help. Something else is taking up the memory. Figure you've got a little shy of 500MB for the mempools. RocksDB will take up more (and potentially quite a bit more if you have memtables backing up waiting to be flushed to L0) and potentially some other things in the OSD itself that could take up memory. If you feel comfortable experimenting, you could try changing the rocksdb WAL/memtable settings. By default we have up to 4 256MB WAL buffers. Instead you could try something like 2 64MB buffers, but be aware this could cause slow performance or even temporary write stalls if you have fast storage. Still, this would only give you up to ~0.9GB back. Since you are on mimic, you might also want to check what your kernel's transparent huge pages configuration is. I don't remember if we backported Patrick's fix to always avoid THP for ceph processes. If your kernel is set to "always", you might consider trying it with "madvise".
Alternately, have you tried the built-in tcmalloc heap profiler? You might be able to get a better sense of where memory is being used with that as well.
Mark
On 7/13/20 7:07 AM, Frank Schilder wrote:
Hi all,
on a mimic 13.2.8 cluster I observe a gradual increase of memory usage by OSD daemons, in particular, under heavy load. For our spinners I use osd_memory_target=2G. The daemons overrun the 2G in virt size rather quickly and grow to something like 4G virtual. The real memory consumption stays more or less around the 2G of the target. There are some overshoots, but these go down again during periods with less load.
What I observe now is that the actual memory consumption slowly grows and OSDs start using more than 2G virtual memory. I see this as slowly growing swap usage despite having more RAM available (swappiness=10). This indicates allocated but unused memory or memory not accessed for a long time, usually a leak. Here some heap stats:
Before restart: osd.101 tcmalloc heap stats:------------------------------------------------ MALLOC: 3438940768 ( 3279.6 MiB) Bytes in use by application MALLOC: + 5611520 ( 5.4 MiB) Bytes in page heap freelist MALLOC: + 257307352 ( 245.4 MiB) Bytes in central cache freelist MALLOC: + 357376 ( 0.3 MiB) Bytes in transfer cache freelist MALLOC: + 6727368 ( 6.4 MiB) Bytes in thread cache freelists MALLOC: + 25559040 ( 24.4 MiB) Bytes in malloc metadata MALLOC: ------------ MALLOC: = 3734503424 ( 3561.5 MiB) Actual memory used (physical + swap) MALLOC: + 575946752 ( 549.3 MiB) Bytes released to OS (aka unmapped) MALLOC: ------------ MALLOC: = 4310450176 ( 4110.8 MiB) Virtual address space used MALLOC: MALLOC: 382884 Spans in use MALLOC: 35 Thread heaps in use MALLOC: 8192 Tcmalloc page size ------------------------------------------------ # ceph daemon osd.101 dump_mempools { "mempool": { "by_pool": { "bloom_filter": { "items": 0, "bytes": 0 }, "bluestore_alloc": { "items": 4691828, "bytes": 37534624 }, "bluestore_cache_data": { "items": 0, "bytes": 0 }, "bluestore_cache_onode": { "items": 51, "bytes": 28968 }, "bluestore_cache_other": { "items": 5761276, "bytes": 46292425 }, "bluestore_fsck": { "items": 0, "bytes": 0 }, "bluestore_txc": { "items": 67, "bytes": 46096 }, "bluestore_writing_deferred": { "items": 208, "bytes": 26037057 }, "bluestore_writing": { "items": 52, "bytes": 6789398 }, "bluefs": { "items": 9478, "bytes": 183720 }, "buffer_anon": { "items": 291450, "bytes": 28093473 }, "buffer_meta": { "items": 546, "bytes": 34944 }, "osd": { "items": 98, "bytes": 1139152 }, "osd_mapbl": { "items": 78, "bytes": 8204276 }, "osd_pglog": { "items": 341944, "bytes": 120607952 }, "osdmap": { "items": 10687217, "bytes": 186830528 }, "osdmap_mapping": { "items": 0, "bytes": 0 }, "pgmap": { "items": 0, "bytes": 0 }, "mds_co": { "items": 0, "bytes": 0 }, "unittest_1": { "items": 0, "bytes": 0 }, "unittest_2": { "items": 0, "bytes": 0 } }, "total": { "items": 21784293, "bytes": 461822613 } } }
Right after restart + health_ok: osd.101 tcmalloc heap stats:------------------------------------------------ MALLOC: 1173996280 ( 1119.6 MiB) Bytes in use by application MALLOC: + 3727360 ( 3.6 MiB) Bytes in page heap freelist MALLOC: + 25493688 ( 24.3 MiB) Bytes in central cache freelist MALLOC: + 17101824 ( 16.3 MiB) Bytes in transfer cache freelist MALLOC: + 20301904 ( 19.4 MiB) Bytes in thread cache freelists MALLOC: + 5242880 ( 5.0 MiB) Bytes in malloc metadata MALLOC: ------------ MALLOC: = 1245863936 ( 1188.1 MiB) Actual memory used (physical + swap) MALLOC: + 20488192 ( 19.5 MiB) Bytes released to OS (aka unmapped) MALLOC: ------------ MALLOC: = 1266352128 ( 1207.7 MiB) Virtual address space used MALLOC: MALLOC: 54160 Spans in use MALLOC: 33 Thread heaps in use MALLOC: 8192 Tcmalloc page size ------------------------------------------------
Am I looking at a memory leak here or are these heap stats expected?
I don't mind the swap usage, it doesn't have impact. I'm just wondering if I need to restart OSDs regularly. The "leakage" above occurred within only 2 months.
Best regards, ================= Frank Schilder AIT Risø Campus Bygning 109, rum S14 _______________________________________________ ceph-users mailing list -- ceph-users@ceph.io To unsubscribe send an email to ceph-users-leave@ceph.io
_______________________________________________ ceph-users mailing list -- ceph-users@ceph.io To unsubscribe send an email to ceph-users-leave@ceph.io
_______________________________________________ ceph-users mailing list -- ceph-users@ceph.io To unsubscribe send an email to ceph-users-leave@ceph.io