Hello from Detroit MI: I have been doing some limited benchmarking of a Squid cluster. The arrangement of the cluster: Server Function c01 MGR, MON c02 MGR, MON o01 OSD o02 OSD o03 OSD o04 OSD Each OSD has 2 x NVME disks for Ceph, each at 370 Gig The backing network is as follows: ens18 Gigabit, mon-ip (192.168.0.0/23) regular MTU (1500) ens19 2.5 Gigabit, Cluster Network (10.0.0.0/24) Jumbo MTU (9000) Behind all this is a small ProxMox cluster. All Ceph machines are running on a single node. All Ceph drives are exposed and an NFS mounted NVME drive. All Ceph OSD drives are mounted with no cache and single controller per drive. Networking bridges are all set to either MTU 9000 or MTU 1500 as appropriate. iPerf3 is showing 2.46 Gbit/sec between servers c01 and o01 on the ens19 network. Firewall is off all the way around. OS is CentOS 10. SELinux of disabled. No network enhancements have been performed (increasing send/rcv buffer size, queue length, etc). The concern given all this: rados bench can't exceed 110 MB/s in all tests. In fact if I didn't know better I would swear that the traffic is being either throttled or is somehow routing through a 1Gbit network. The numbers that are returning from rados bench are acting like saturation at Gigabit and not exhibiting any evidence of being on a 2.5 Gbit network. Monitoring at both Ceph and ProxMox consoles confirm the same. Cluster traffic is confirmed to be going out ens19 - tested via tcpdump. Typical command line used for rados bench: rados bench -p s3block 20 write What the heck am I doing wrong here? Ron Gage