Hi Eugen, I have found these threads and am not entirely convinced that they apply to our situation. Most importantly, the IP addresses cannot be clients, because they are in the replication network, which clients don't have access to. The formulation of the message sounds a lot like a PG peer is using v1 instead of v2. Both peers in the log message have v1 and v2 addresses though. The log messages with v1 clients looked different. Apart from that, if this is normal, why the continuous log entries - why not just one on connect? I can't get the old kernel clients to talk v2, so its basically log spam. Let's say its the clients, I didn't see a resolution. How can I shut off these messages? Thanks a lot! ================= Frank Schilder AIT Risø Campus Bygning 109, rum S14 ________________________________________ From: Eugen Block <eblock(a)nde.ag> Sent: 17 January 2023 10:02:13 To: ceph-users(a)ceph.io Subject: [ceph-users] Re: ._handle_peer_banner peer [v2:***,v1:***] is using msgr V1 protocol Hi, this sounds familiar, I believe this means that (some) of your clients are using msgr_v1. I assume that your MONs are configured to use both v1 and v2? I read somewhere that kernel clients might not support v2, but I'm not really sure. But there are a couple of threads discussing this. Regards, Eugen Zitat von Frank Schilder <frans(a)dtu.dk>dk>: _______________________________________________ ceph-users mailing list -- ceph-users(a)ceph.io To unsubscribe send an email to ceph-users-leave(a)ceph.io